I have been asking around but no one seems to have a good answer. Here is my problem I have a cmc 6 inch manual plate. The plate is in the top holes on the transom side and the motor is one hole from the top of the motor bracket. With everything topped out I am at just over 4 1/2 inches below the pad with the prop shaft. Need to go higher, but I am looking for a good way to do so or a suggestion on what to buy.
I can buy extensions for the cmc plate that is on it. I would just buy a new manual plate if I new it would get the motor high enough with out extensions. What is everyone running to get a 20inch motor even with the pad and still have adjustment up and down.
[ Post made via Android ]
Wondering how to post images or maybe change your avatar or maybe something else?
You can find that and a lot of other useful tips for using the forums in the HydrostreamForums Knowledge Base.
To visit the HydrostreamForums Knowledge Base CLICK HERE
You can find that and a lot of other useful tips for using the forums in the HydrostreamForums Knowledge Base.
To visit the HydrostreamForums Knowledge Base CLICK HERE
How to get motor higher on a vulture?
-
- Regular
- Posts: 174
- Joined: Jun 03, 2012 8:29 pm
- Location: MA
- Been thanked: 6 times
- Contact:
Re: How to get motor higher on a vulture?
lets see a picture please.. the way you explained it i think you can bolt the motor higher on the boat and or jackplate..
-
- Random Topics
- Replies
- Views
- Last post
-
- 2Replies
- 12668 Views
- Last post by Hippie459MN
Apr 08, 2009 9:14 pm
-
- 5Replies
- 16483 Views
- Last post by oldskier
Apr 08, 2009 9:22 pm
-
- 5Replies
- 16154 Views
- Last post by Hippie459MN
Apr 16, 2009 4:15 pm
-
- 7Replies
- 28110 Views
- Last post by Vegas XT
Apr 18, 2009 8:39 pm
-
- 17Replies
- 36086 Views
- Last post by dnr78
Apr 19, 2009 6:48 pm
Who is online
Users browsing this forum: No registered users and 9 guests