Welcome to HydrostreamForums.com
If you're not registered, please consider doing so. It's easy - just click the "Register" link at the top
right corner of the page. Our forum needs members like you to contribute to the site in order to survive.
We are a community of boat lovers and Hydrostream enthusiasts here; we are happy to help anyone
who may need advice or guidance for their 'Stream; and we encourage members to offer their advice
and guidance to others as well. Thank you for visiting our forums, and please register.
We're better than Facebook.

Registering only takes a few minutes and you can do so by CLICKING HERE

If you are a member, don't forget to log in to take full advantage of the forum.

175 johnson tilt trim

Have questions about setting up your boat? Engine height, setback, prop, etc.
Post Reply
User avatar

Topic Author
jaybrown
The new guy
The new guy
Posts: 5
Joined: May 24, 2017 3:21 pm
Location: haliburton ontario

175 johnson tilt trim

Post by jaybrown » Jun 06, 2017 7:36 pm

My 175 will tilt up when im going slow but as soon as i give it throttle it like shoots back down to the down position. it likes shoots back down onto the 2 post that come out i think thats the trim then the single cylinder in the middel is tilt? but it seems the cylinder in the center wont hold up the motor under power and the pump was just rebuilt?

User avatar

bruzercomp81
Getting my feet wet
Getting my feet wet
Posts: 24
Joined: Dec 20, 2013 9:08 am
Location: hartford
Has thanked: 1 time
Been thanked: 1 time

Re: 175 johnson tilt trim

Post by bruzercomp81 » Sep 14, 2017 8:49 pm

The center ram is just tilt and usually doesn't support the pressure of any throttle. It should like you have your motor trimmed to high. Do you have any pics of your setup?

[ Post made via Android ] Image

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest