Welcome to HydrostreamForums.com
If you're not registered, please consider doing so. It's easy - just click the "Register" link at the top
right corner of the page. Our forum needs members like you to contribute to the site in order to survive.
We are a community of boat lovers and Hydrostream enthusiasts here; we are happy to help anyone
who may need advice or guidance for their 'Stream; and we encourage members to offer their advice
and guidance to others as well. Thank you for visiting our forums, and please register.
We're better than Facebook.

Registering only takes a few minutes and you can do so by CLICKING HERE

If you are a member, don't forget to log in to take full advantage of the forum.

Project Hydrostream Vulture

Restoring your Hydrostream or just giving it a small makeover? What better place than to show off your project. Big or small.
User avatar

Topic Author
Hippie459MN
Site Admin
Site Admin
Posts: 3485
Joined: Mar 25, 2009 7:31 pm
Location: Crown, MN
Has thanked: 70 times
Been thanked: 17 times
Contact:

Re: Project Hydrostream Vulture

Post by Hippie459MN » Jul 05, 2017 2:46 pm

Going to be doing some body work and some rattle can painting stuff on the back of the Vulture this weekend finally to get me by until I can get the whole boat painted and wondering what I should use to fill in the holes in the transom? I do have a little bit of duraglass and also some Marine-Tex Epoxy Putty here I can use. All suggestions welcome. Thanks.
20170705_135441_resize.jpg
20170705_135441_resize.jpg (1.06 MiB) Viewed 104 times
:boating:
-Kevin
Project Vulture | Project Vector | Project Vamp
The Vulture Wish List | Project CobraJet

1977 HydroStream Vulture - Worlds longest ongoing project. :eek:
1982 Hydrostream Vector
1982 Hydrostream Vamp
1976 CobraJet Jet Boat - Outboard conversion project
199? Glastron - aka Boat Anchor
1976 Pontoon - aka The Family Truckster

User avatar

Streamer
HSF Lifetime Supporter
HSF Lifetime Supporter
Posts: 43
Joined: Aug 24, 2015 8:28 am
Location: Kingsport USA
Has thanked: 4 times
Been thanked: 8 times

Re: Project Hydrostream Vulture

Post by Streamer » Jul 16, 2017 10:10 pm

Just installed my transom and it looks similar to yours now with plugged holes and patches, etc on the back side.
I am going to clean, sand and make it flat, then a layer of glass over it. Then get it prepped and ready for when the boat gets painted.

This picture was a practice fit with clamps in place before it actually got glassed in.
Attachments
Rear dry run before glassing in transom.jpg
Rear dry run before glassing in transom.jpg (81.06 KiB) Viewed 85 times
79 Vector needs restore (on hold for now)
79 V-King getting restored (WIP)

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests