Wondering how to post images or maybe change your avatar or maybe something else?
You can find that and a lot of other useful tips for using the forums in the HydrostreamForums Knowledge Base.
To visit the HydrostreamForums Knowledge Base CLICK HERE
You can find that and a lot of other useful tips for using the forums in the HydrostreamForums Knowledge Base.
To visit the HydrostreamForums Knowledge Base CLICK HERE
splashwell corner CRACKED again!
Re: splashwell corner CRACKED again!
I know it is pain, but I have seen a lot of finished become unfinished with these pesky cracks at the corners. the only way I have found to fully cure this, is prior to paint or gel, LAY A COUPLE LAYERS OF, SAY, 3 OR 4 OUNCE S-GLASS IN THE DIRECTION OF THE STRESS (PARALLEL TO THE BOAT SIDES) AND A LAYER THAT IS ORIENTED ABOUT 45 DEGREES LEFT, AND THEN ANOTHER RIGHT. THE TRANSOM WILL BE A LITTLE THICKER, BUT NOT MUCH, AND YOU WILL HAVE A GREAT DEAL MORE STRENGTH ON THE SKIN, WHICH IS WHRE THE STRESS REALLY OCCURS UNDER POWER. START THE GLASS IN THE SPLASH WELL AREA AND WRAP UP AND OVER ONTO THE OUTSIDE SKIN OF THE TRANSOM. BY USING THESE THIN LAYERS, THE GLASS IS EASIER TO LAY IN PROPERLY WITHOUT THE NEED FOR A LOT OF VACUUM BAGGING. YOU CAN SIMPLY PUT BRICKS OR WHATER ON TOP TO HOLD POSITION AT THE SHARP ANGLES.
-
- Random Topics
- Replies
- Views
- Last post
-
- 3Replies
- 2686 Views
- Last post by dehydrated
May 16, 2010 10:24 pm
-
- 2Replies
- 2648 Views
- Last post by Hippie459MN
May 17, 2010 11:12 am
-
- 1Replies
- 2596 Views
- Last post by Hydrostream Bot
May 17, 2010 8:55 pm
-
- 3Replies
- 2914 Views
- Last post by Hippie459MN
May 19, 2010 8:37 am
-
- 1Replies
- 2123 Views
- Last post by Hydrostream Bot
May 18, 2010 7:40 pm
Who is online
Users browsing this forum: No registered users and 7 guests