Welcome to HydrostreamForums.com
Dont forget to log in or register to take full advantage of the forums.

It only takes a few minutes to register and you can do so by CLICKING HERE

Transom shape?

Have questions about fiberglass, gel-coat, or core repairs well as composite questions?
Post Reply
User avatar

Topic Author
Posts: 110
Joined: Jul 19, 2016 6:58 pm
Location: Toronto, Ontario
Has thanked: 10 times
Been thanked: 12 times

Transom shape?

Post by AdamDK » Apr 14, 2017 9:51 pm

Just wondering what peoples opinions are on the "shape" of their transoms. Specifically, I'm curious as to how builders deal with having to wrap the fiberglass around the edge then bend it back to the hull by the "wing" area.

Do you bevel the side edges so it conforms to the shape of the hull?
Use a filler compound for the "triangle" area?
Bevel the opposite angle to make the glass conform easier?

Behold my amazing MS Paint skillz.



User avatar

Site Admin
Site Admin
Posts: 3457
Joined: Mar 25, 2009 7:31 pm
Location: Crown, MN
Has thanked: 56 times
Been thanked: 15 times

Re: Transom shape?

Post by Hippie459MN » Apr 15, 2017 10:26 am

The transom on these are perfectly square. Super easy. Go look at my rebuild topic and you will see. For the edges, we used resin with cabosil in it and just made a nice contour then put some 1708 over it to seal it all up.

The transom starts here - viewtopic.php?f=13&t=1171&start=40

Hope that helps. :)
Project Vulture | Project Vector | Project Vamp
The Vulture Wish List | Project CobraJet

1977 HydroStream Vulture - Worlds longest ongoing project. :eek:
1982 Hydrostream Vector
1982 Hydrostream Vamp
1976 CobraJet Jet Boat - Outboard conversion project
199? Glastron - aka Boat Anchor
1976 Pontoon - aka The Family Truckster

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests