I have the core and stringer work completed and have started looking at the floor.
I expected the main floor would be more or less flat. It's not.
The middle 6' of the 8' long floor is pretty flat. The front end curves upwards 1" on the port side and and 1/2" on the starboard side. It also kicks up at the transom, but not as severely.
It is an 89 V-King and I am using 1/2" marine grade plywood for the floor.
I think the port/starboard discrepancy is caused by a previous repair on the port side.
No point asking if this curve is normal because it is what it is.
I am wondering about installing the floor.
With the naked plywood (not sealed), the curves are achievable with modest weight. But it needs to be sealed, right?
I am wondering about sealing the bottom of the floor and then bending it in tension. Polyester resin will possibly crack and then we have lost the seal.
How are other prepping the bottom side of the plywood? Resin, resin and glass, other?
Does the floor need to be in one piece? 3 pieces would lay pretty.
Maybe put a couple of 1/4" deep score cuts across the bottom?
Wondering how to post images or maybe change your avatar or maybe something else?
You can find that and a lot of other useful tips for using the forums in the HydrostreamForums Knowledge Base.
To visit the HydrostreamForums Knowledge Base CLICK HERE
You can find that and a lot of other useful tips for using the forums in the HydrostreamForums Knowledge Base.
To visit the HydrostreamForums Knowledge Base CLICK HERE
V-King Floor
-
- Getting my feet wet
- Posts: 24
- Joined: Jul 12, 2022 10:41 am
- Location: Oshawa, Ontario
- Has thanked: 1 time
- Been thanked: 1 time
- Contact:
-
- Random Topics
- Replies
- Views
- Last post
-
- 7Replies
- 4688 Views
- Last post by rossi
Dec 31, 2014 9:04 pm
-
- 18Replies
- 8381 Views
- Last post by SteveFlorioJr
May 10, 2014 7:25 pm
-
- 16Replies
- 15133 Views
- Last post by rev.ronnie
Oct 03, 2014 1:27 am
-
- 3Replies
- 6680 Views
- Last post by Streamin Again
May 13, 2014 11:42 am
-
- 3Replies
- 6963 Views
- Last post by Hippie459MN
Sep 06, 2015 12:29 am
Who is online
Users browsing this forum: No registered users and 72 guests