Hydrostreamforums.com - The only dedicated Hydrostream forum

I was in the motor yesterday and was looking at the carbs the top one looks like its open at full but the middle carb looks like it should be more open and i cant really see the bottom one, is there a thread on adjusting or "syncing" these to open them or does anyone have experience on these carbs?

[ Post made via Android ]

There should be a screw on top of middle and bottom carb where the plastic shafts come down from top and middle carb that has a slot, loosen the screw on the middle carb and hold top carb full open ( may need a second set of hands or tie open the top carb) then hold middle carb full open and tighten screw, do the same for bottom carb, also check the plastic shafts for breaks. I hope this helps wish I could send you some pics

[ Post made via iPhone ]

Thanks Varmint, I see where the plastic and screw and housing are the plastic looks in good condition im going to give it a go.

[ Post made via Android ]

here is a pic of the middle carb at full throttle the bottom carb was turned in even more than this i dont know how far off this is im not a mechanic but i adjusted them and they are all straight open now:)

[ Post made via Android ]

Hope to hear some good results now that your carbs are opening all the way, what size 6 you running

[ Post made via iPhone ]

its a 74 115 but it was rebuilt and bored two years its maybe got 50 to 60 hours on it

[ Post made via Android ]