Wondering how to post images or maybe change your avatar or maybe something else?
You can find that and a lot of other useful tips for using the forums in the HydrostreamForums Knowledge Base.
To visit the HydrostreamForums Knowledge Base CLICK HERE
You can find that and a lot of other useful tips for using the forums in the HydrostreamForums Knowledge Base.
To visit the HydrostreamForums Knowledge Base CLICK HERE
AE-21 Rigging
-
- Site Admin
- Posts: 3970
- Joined: Mar 25, 2009 7:31 pm
- Location: Nowthen, MN
- Has thanked: 349 times
- Been thanked: 81 times
- Contact:
Re: AE-21 Rigging
That thing looks awesome!!!!! Thats one stream I would not let go of if it was mine. Great job and looks like it flies nice too...
[youtube]http://www.youtube.com/watch?v=gC6aihCAIZQ[/youtube]
[youtube]http://www.youtube.com/watch?v=gC6aihCAIZQ[/youtube]
-Kevin
Project Vulture | Project Vector | Project Vamp | Project Vixen
The Vulture Wish List | Project CobraJet
1977 HydroStream Vulture - Worlds longest ongoing project.
1982 Hydrostream Vector
1982 Hydrostream Vamp
1973 Hydrostream Vixen
1976 CobraJet Jet Boat - Outboard conversion project
1976 Pontoon - aka The Family Truckster
Project Vulture | Project Vector | Project Vamp | Project Vixen
The Vulture Wish List | Project CobraJet
1977 HydroStream Vulture - Worlds longest ongoing project.
1982 Hydrostream Vector
1982 Hydrostream Vamp
1973 Hydrostream Vixen
1976 CobraJet Jet Boat - Outboard conversion project
1976 Pontoon - aka The Family Truckster
-
- The new guy
- Posts: 2
- Joined: Apr 03, 2011 11:42 am
- Contact:
Re: AE-21 Rigging
Jupiter inlet brings back memories. Is the sandbar still across the inlet at the ocean? Me and my dad toof the rudder of a sailboat on that bar back around 1979. Had to put the boat on a bar a little further in and wait for the tide to go out to do a temporary repair. We were on the way back to Key West, but Jupiter looked like it had some good boating water.
79 Viking Rude 225
79 Viking Rude 225
-
- Regular
- Posts: 127
- Joined: May 23, 2009 3:57 pm
- Location: Jupiter, FL
- Contact:
Re: AE-21 Rigging
There is a sandbar west of the Jupiter inlet and train trestle bridge (old dixie) that alot of boats gather at. Some people pull the boats onto the sand right in front of the Jupiter Lighthouse..you may be thinking of St. Lucie inlet (north of Jupiter by 30 minutes) where there is a large sandbar in the middle of the inlet. Jupiter gives you a variety of good intercoastal, back country and ocean running!!silkeysak55 wrote:Jupiter inlet brings back memories. Is the sandbar still across the inlet at the ocean? Me and my dad toof the rudder of a sailboat on that bar back around 1979. Had to put the boat on a bar a little further in and wait for the tide to go out to do a temporary repair. We were on the way back to Key West, but Jupiter looked like it had some good boating water.
79 Viking Rude 225
1991 Canadian Edition AE-21/Merc 2.5
1997 Checkmate Pulsare 2100/under the knife
1994 Checkmate Pulsare 2100/Merc 225Xri-SOLD
1988 Valero YT Bowrider/Merc 175-SOLD
1997 Checkmate Pulsare 2100/under the knife
1994 Checkmate Pulsare 2100/Merc 225Xri-SOLD
1988 Valero YT Bowrider/Merc 175-SOLD
-
- The new guy
- Posts: 5
- Joined: Jun 01, 2011 8:15 pm
- Contact:
Re: AE-21 Rigging
I spent 4 hours and a tank of gas getting to know her! I was running 50/1 break in oil so I couldn't run hard...but I did make a few 6000 rpm passes...just enought to pack some air and get the hull to "fly" !! I have a few bugs to work out..stuck pop it valve, bad sending unit for water temp, need to secure my rear bench seat bottom from sliding around, etc. but all worked out great! The boat drew attention everywhere we went!!
Signature removed due to advertising non supported commercial products.
-Hippie459MN
-Hippie459MN
-
- Getting my feet wet
- Posts: 30
- Joined: May 31, 2011 10:06 am
- Location: Ottawa, Ontario
- Contact:
Re: AE-21 Rigging
love the colours of that boat!
________________________________
1985 JCraft Pro Ski
150 Mercury XR6
1985 JCraft Pro Ski
150 Mercury XR6
-
- Regular
- Posts: 127
- Joined: May 23, 2009 3:57 pm
- Location: Jupiter, FL
- Contact:
Re: AE-21 Rigging
From Sunday last week: AE-21 side by side with an HST!!
1991 Canadian Edition AE-21/Merc 2.5
1997 Checkmate Pulsare 2100/under the knife
1994 Checkmate Pulsare 2100/Merc 225Xri-SOLD
1988 Valero YT Bowrider/Merc 175-SOLD
1997 Checkmate Pulsare 2100/under the knife
1994 Checkmate Pulsare 2100/Merc 225Xri-SOLD
1988 Valero YT Bowrider/Merc 175-SOLD
-
- Site Admin
- Posts: 3970
- Joined: Mar 25, 2009 7:31 pm
- Location: Nowthen, MN
- Has thanked: 349 times
- Been thanked: 81 times
- Contact:
Re: AE-21 Rigging
Nice! But how about a bigger picture.
-Kevin
Project Vulture | Project Vector | Project Vamp | Project Vixen
The Vulture Wish List | Project CobraJet
1977 HydroStream Vulture - Worlds longest ongoing project.
1982 Hydrostream Vector
1982 Hydrostream Vamp
1973 Hydrostream Vixen
1976 CobraJet Jet Boat - Outboard conversion project
1976 Pontoon - aka The Family Truckster
Project Vulture | Project Vector | Project Vamp | Project Vixen
The Vulture Wish List | Project CobraJet
1977 HydroStream Vulture - Worlds longest ongoing project.
1982 Hydrostream Vector
1982 Hydrostream Vamp
1973 Hydrostream Vixen
1976 CobraJet Jet Boat - Outboard conversion project
1976 Pontoon - aka The Family Truckster
-
- Random Topics
- Replies
- Views
- Last post
-
- 1Replies
- 20484 Views
- Last post by slowjoe
Mar 30, 2021 7:36 pm
-
- 14Replies
- 38957 Views
- Last post by harrells1
May 22, 2022 8:52 am
-
- 3Replies
- 16520 Views
- Last post by AdamDK
Jun 23, 2021 6:49 pm
-
- 2Replies
- 15450 Views
- Last post by tnelson77
Apr 15, 2021 11:07 am
-
- 3Replies
- 23751 Views
- Last post by Hippie459MN
May 07, 2021 5:19 pm
Who is online
Users browsing this forum: No registered users and 6 guests