Welcome to HydrostreamForums.com
If you're not registered, please consider doing so. It's easy - just click the "Register" link at the top
right corner of the page. Our forum needs members like you to contribute to the site in order to survive.
We are a community of boat lovers and Hydrostream enthusiasts here; we are happy to help anyone
who may need advice or guidance for their 'Stream; and we encourage members to offer their advice
and guidance to others as well. Thank you for visiting our forums, and please register. We're better than Facebook.
Registering only takes a few minutes and you can do so by CLICKING HERE
If you are a member, don't forget to log in to take full advantage of the forum.
Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
Transom has been drilled for the top holes, still need to measure and drill the lower holes. But I also need to order some parts from CMC because the last owner snapped the upper ram bolt and bent the lower ram bolt. They just ran it like that for awhile and ended up damaging the mounts.
Spent a week pulling the kids around on a tube, the boat did amazing! The trailer had some issues though, one of the u bolts holding the axle to the leaf spring snapped and dropped the trailer to the ground... took some hack job repairs to get the trailer moving again, but I got it to a repair shop to get a new u-bolt and a new bearing put in.