Page 1 of 1
drag racing help
Posted: May 16, 2011 12:17 pm
by 81vector
Where should I have my prop shaft at in reference to my pad on a vector for a 1000ft drag race I am running a 24 yamaha on a 2.4 225 merc with a lwp
[ Post made via Mobile Device ] 
Re: drag racing help
Posted: May 16, 2011 3:37 pm
by 77viper
I would start even with the pad, you might end up 1/2" up or down from there. There are too many variables to give you a exact height.
I run my 2.4 1/4" up on my viper but I have no interior in my boat.
Re: drag racing help
Posted: May 16, 2011 7:37 pm
by 81vector
Ok I will try that
[ Post made via Mobile Device ]
Re: drag racing help
Posted: May 16, 2011 7:38 pm
by 81vector
I don't have any interior in my boat either just a front seat back seat battery and fuel tank and my seats r plastic
[ Post made via Mobile Device ]