Hydrostreamforums.com - The only dedicated Hydrostream forum

hello i have a 1984 vector but i noticed the boat doesn't have a hull fitting for the bilge pump.got a new bilge pump and hose cause boat didn't have one when i got boat. i also noticed boat sits low in water in the back. was wondering if anyone knows the proper location for the hull fitting. thank you

...could be wrong but I don't think they typically installed those at the factory, so its your call. In the past, I have rigged them to dump it in the motor well. Then it would drain out from there. It worked well and I didn't have to make a hole in the side of the boat.

thanx surface scratcher i was thinking the same thing cause boat sits low in the water