Was there yesterday had a great time

[ Post made via Android ]

32:1 is too much oil for a fishing motor. You will foul plugs and end up getting carbon deposits behind the rings. Not good. Pistons swell and the rings need the groove to move into. At 5800 rpm's, a proper oil injection is putting out 50:1. As the throttle is backed off, the oil is reduced (in an ...

Well put my new Bob's low water pickup on and put in a new water pump while I had the lower unit off thats not to bad of a job at all.Theres alot of water psi now how much water psi should I have now with the 85 200 Merc .just idling 17 psi and it go 's up to 20 something and warms up to 165 170 tem...

It can be tig welded .Looks like someone hit it with a hammer maybe trying to steel you prop or something.I would sand alittle past the crack to make sure thats were the crack ends .A good welder will drill a hole at the end of the crack to stop the crack . Good luck

6" will work but I would go 8-10" if your cables are long enough. Like I said I have 12" on mine and as long as you're going hyd. it's easy to adjust for passenger load. Cables for my hot foot you mean ? I have 2 stearing boxs hydrolic. I better get my fat butt under the dash and tak...

Yes it's all original 1986 Vegas xt 200 motor .mix at 32: 1the motor has been warm over. I beleave I'm the 2nd owner of her. Looking at Venus to buy and a HST . each kid is going to have a Hydrostream . My wife's aunt has a cherry 90 Vegas with 175 Rude .Well that jack plate will be a 6'' then I'll ...